|
Impala Page 7  
This
is my first attempt at metal fabrication. Top left is
the before shot, 2nd is old piece cut out and new one clamped in
place. Bottom left is the inside shot. I bent and hammered
the corner piece and angle bracket out on my vice with a piece of
railroad track. I still have to drill the hole for the body mount
in the corner there, but not sure where to drill it exactly. The
measurements in the manual don't jive with my frame. How can that
be? I think I am going to have to take my measurments from
the body holes. These are all the driver side shots.
 
(added October 14, 2009) 
|
